Originally posted by Thomas Callan
I pledged these two MetMo drivers on Kickstarter and am very happy with the finished products. Incredible design and machining! I converted both units to stainless steel barrels and one custom handle. The conversion went very well! I have a twofold rationale for buying the MetMo drivers: torque and control. I have stripped screw heads many times with my portable drills and as many times have not had the torque to complete a project. “Hats off!” To MetMo for solving both issues!
Originally posted by annag
How did you decide on how to organise the expansion bits in their case? The longest extension bit seems tricky to know where to place.
Originally posted by Thomas Callan
annag,
I agree…the placement isn’t ideal because of its length. This is how I did it.
Originally posted by William Adams
Thomas, I went for pretty much the opposite orientation — my rationale was that the smaller bits/adapters would not abrade against the handle (and flipping the longest extender put it up against the void created by the narrow stainless steel end).
I still think a flap/protector for the longest bit extension which would then cover the bits and add a bit of compressible bulk when rolling things up would help — I’m currently using a folded piece of cardboard, but am going to be looking for a matching piece of leather presently.
Originally posted by Thomas Callan
William, Good pointI was planning to carry the driver in its case, but it would be better to combine it with the roll as you suggest.
